MATERIAL
SAFETY DATA SHEET
100 Ink Series (CODETAPER INK) |
Material Safety Data Sheet
May be used to comply with OSHA's Hazard Communication Standard, 29 CFR
1910.1200 Standard must be consulted for specific requirements. |
U-S- Department of Labor
Occupational Safety and Health Administration
(Non-Mandatory Form)
Form Approved OMB No. 1218-0072 |
Identity: (As Used on Label and
List)
100 Ink Series (CODETAPER INK) |
|
| The information contained in this MSDS
pertains to this ink used in large quantities by industrial and manufacturing personnel.
The amount of ink in a stamp pad is very small. This MSDS should be a general reference to
assist users of this product. Date Prepared: March, 12, 1999 |
| SECTION 1 - MANUFACTURER'S INFORMATION - MANUFACTURER'S INFORMATION
SECTION 1 - MANUFACTURER'S INFORMATION |
RANGER
INDUSTRIES
15 PARK ROAD
TINTON FALLS, NJ 07724 |
Telephone Numbers:
EMERGENCY-CHEMTRECH (800) 424-9300
INFORMATION (732) 389-3535 |
Hazardous Components OSHA(PEL) ACGIH (TLV)
|
| SECTION 2 - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION |
Hazardous Components
OSHA(PEL)
ACGIH (TLV)
NONE
|
| HAZARDOUS MATERIAL IDENTIFICATION SYSTEM
(HMIS) |
| 4 = EXTREME 3 = HIGH |
HEALTH |
FIRE
REACTIVITY |
| 1 |
0
0 |
| 2 = MODERATE |
1 = SLIGHT
0 = INSIGNIFICANT |
SECTION 3 -
PHYSICAL/CHEMICAL CHARACTERISTICS |
Boiling point ñ 212°
Vapor pressure (mm Hg.) NOT ESTABLISHED
Vapor density (Air = 1) NOT ESTABLISHED
Specific gravity (Water = 1) ñ 1
pH 6.0 - 7.5
Melting point NOT APPLICABLE
Evaporation Rate (Butyl Acetate = 1) ñ 1
Solubility in Water COMPLETE
Appearance and Odor: COLORED LIQUID, MILD ODOR |
| |
SECTION 4 -
FIRE AND EXPLOSION HAZARD DATA |
Flash point (Method
Used) NOT APPLICABLE. THIS INK MIXTURE IS A WATER BASED PRODUCT.
IT IS NOT EXPECTED TO BURN UNTIL ALL THE WATER HAS BOILED OFF.
Flammable Limits LEL NOT DETERMINED
UEL NOT DETERMINED
Extinguishing Media WATER SPRAY, ALL PURPOSE FOAM FOR LARGE FIRES. CO2,
DRY CHEMICAL FOR SMALL FIRES.
Special fire-fighting procedures
SELF-CONTAINED BREATHING APPARATUS, PROTECTIVE CLOTHING,
WATER SPRAY TO COOL FIRE EXPOSED CONTAINERS AND STRUCTURES AND TO DISPERSE VAPORS.
Unusual fire & explosion hazards NONE
KNOWN |
| |
SECTION 5 -
REACTIVITY DATA |
| Stability |
INK MIXTURE IS STABLE |
| Conditions to avoid |
NONE SPECIFICALLY RECOMMENDED |
| Incompatibility (Materials to
avoid) |
STRONG OXIDIZERS |
| Hazardous decomposition or
By-products |
CO, CO2, H20, OXIDES OF NITROGEN, HYDROGEN CHLORIDE AND OTHER
PRODUCTS. |
| Hazardous polymerization |
Will not occur. |
| Conditions to Avoid
NONE SPECIFICALLY RECOMMENDED |
| |
SECTION 6 -
HEALTH HAZARD DATA |
| Routes of Entry: |
|
| Inhalation? |
NOT AT AMBIENT TEMPERATURE |
| Skin? |
LIQUID MAY COME IN CONTACT WITH SKIN |
| Eyes? |
LIQUID MAY COME IN CONTACT WITH EYES |
| Ingestion? |
POSSIBLE, BUT SHOULD BE AVOIDED |
| Carcinogenicity: |
|
| NTP? Not Listed
IARC Monographs? Not Listed OSHA Regulated: Not
Listed |
MEDICAL CONDITIONS
GENERALLY AGGRAVATED BY OVEREXPOSURE
None KnownOTHER HEALTH HAZARDS:
EFFECTS OF EXPOSURE
INHALATION: None under ambient conditions. Large amount of aerosoling may generate
airborne levels sufficient to cause adverse effects.
EYES: Contact with eyes can cause irritation.
SKIN: Prolonged or repeated exposure may cause localized irritation.
INGESTION: Moderately toxic; may cause pain or discomfort to the gastrointestinal tract.
EFFECTS OF REPEATED OVEREXPOSURE: Same as above
Emergency and First Aid Procedures
INHALATION: No adverse efforts anticipated by this route of exposure incidental to proper
handling. If exposure occurs at elevated temperature, remove to fresh air and get medical
attention as needed. EYES: Immediately flush with water and continue washing for several
minutes. If irritation develops, get medical attention.
SKIN: Wash skin with soap and water. It irritation develops, get medical attention.
INGESTION: If person is fully conscious, give 2 glasses of water. Do not induce vomiting,
unless directed by a physician. Obtain medical attention.
NOTE TO PHYSICIAN: There is no specific antidote. Supportive care, treatment
based on judgement of the physician in response to reactions of the patient. |
SECTION 7 -
PRECAUTIONS FOR SAFE HANDLING AND USE |
Steps
to be Taken in Case Material is Released or Spilled
Small spills: Soak up with absorbent material. Large spills: Dike to prevent
contamination of waterways, then pump into suitable containers.
Waste Disposal Method
Follow Federal, State and Local regulations. Do not discharge into waterways or sewer
systems.
Hazardous Waste 40 CFR 261: NO
Hazardous Waste Number: Not Applicable
Reportable Quantity: None
Precautions to be Taken in Handling or Storing:
Seal containers when not in use. Do not store near heat and open flame. To maintain
product quality, store in cool, dark, dry area.
Other Precautions:
None specifically recommended |
| |
SECTION 8 -
CONTROL MEASURES |
| Respiratory
Protection (Specify Type): None required under ambient conditions.
NIOSH/MESA
approved organic respirator may be required if a large degree of aerosoling occurs.
Ventilation: Local Exhaust
Not needed under ambient conditions and normal use of product. Mechanical (General)
Not needed under ambient conditions and normal use of product.
Other: None specifically recommended
Other Protective Clothing or Equipment
Safety goggles, general purpose rubber gloves, Protective clothing, protective
foot wear, eye fountain and shower.
Work/Hygienic Practices
Standard good hygiene should always be practiced. |
| |
SECTION 9 -
REGULATORY INFORMATION |
| STATUS ON SUBSTANCE LISTS FEDERAL EPA
SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT OF 1986 (SARA) TITLE III Sec. 311/312
Listed: Not Listed
SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT OF 1986 (SARA) TITLE III Sec. 313 and 40 CFR
Part 372: Listed: Not Listed
STATE RIGHT-TO-KNOW
None Known
OTHER REGULATORY INFORMATION
The materials present in this mixture are listed in the TSCA (USA) inventory.
Coalition of Northeastern Governors (CONEG)
No intentional addition of Lead, Cadmium, Mercury, or Hexavalent Chromium has been made to
this product. To the best of our knowledge, the total incidental amount of the four metals
listed above does not exceed 100 ppm.
NOTICE: The opinions expressed are those of qualified persons within Ranger
Industries. We believe that the information contained is accurate and current as of this
date of the Material Safety Data Sheet. Since the use of this information and of these
opinions and the conditions of the use of the product are not within the control of Ranger Industries, it is the user's
obligation to determine the conditions for their safe use of this product. |
